48” individual shoulder harness are ideal for
use in vehicles that have roll cages with the horizontal
cross bar fabricated directly behind the drivers seat.
All 3" harnesses are SFI homologated. Warning:
It is strongly recommended that the shoulder harnesses
are fitted as close to horizontal as possible. It is
a must that the angle of the shoulder harness does not
exceed 45 degrees in relation to the theoretical horizontal
axis of the mounting points. It is recommended that
the harnesses be mounted to the fixing points suggested
by the car manufacturer. The fixing points should always
be reinforced by a steel plate fitted on the outer side
of the car, not by welding or pop riveting. After an
accident or a heavy crash, it is a must to replace the
harnesses and carefully re-check their fixing points
in the car. Belts do not have to be in contact with
parts which can damage it. Should the belt show any
wearing or cuts, it must be immediately replaced.
|
